We printed these plastic spacers to center the front wheels on a 4x4 1st gen Dodge. These should work for any STOCK WHEEL 4x4DUALLY W/FLAT LUGNUTS. We found the factory wheel centering mechanism is a very poor design and allows the wheel to have a ton of runout and cause tire vibrations. These press firmly onto the hub and are not visible with the hub caps installed. They are intended to be left in place. We have not confirmed if these fit a 2wd truck yet, if you would like to confirm if they will fit on your vehicle the measurements are 4.557" HUB diameter, and 4.765" WHEEL bore diameter.
IMPORTANT NOTE : These are a very snug fit, use a wire brush on the hub before attempting to install the sleeves and make sure the inner diameter of the wheel is clean as well.
