4TH Gen Dodge Dash Removal

HERE IS THE CHECKLIST FOR DASH REMOVAL ON THE 4TH GEN, IT IS FREE FOR ALL TO COPY AND PASTE!

4^th gen dash removal

Console has wires under driver seat

Two console bolts by seat belts

Two console bolts in the front behind plastics and two Phillips screws

Two screws under rubber tray at front of console

Main console electrical connector after sliding console back a few inches

Remove plastic duct for center console if applicable (center on the floor)

Park brake

Hood release

Steering shaft bolt

Unplug all steering column wires (requires removal of plastic covers behind steering wheel)

Remove entire column (ensure steering wheel does not rotate or you can damage the clock spring)

Two bolts above column that were hidden by steering column

Remove ENTIRE brake switch to prevent damage

Obd2 port

A pillar covers on both sides

Connections behind a pillars

Two bulk heads on driver floor

Plugs behind pass kick panel (some have two antenna connections)

Two bolts by windshield

Two bolts to main dash brace at the floor above transmission tunnel

If center console truck, remove u shaped metal bracket in center of floor so it doesn’t rip seats

Pull carpet back on both sides to get enough slack in air bag module wires, also helps to release the bottom most clip from the dash that has these wires and a couple of the clips under the carpet.

To remove the hvac box just remove the two nuts on firewall side, one is coolant res mount and other is in plain sight. 

Modify blend door that Blend Door USA sends that is clearly not the correct shape

Relearn blend doors after done