2ND Gen Dodge Dash Removal ('94-'97)

HERE IS THE CHECKLIST FOR DASH REMOVAL ON THE 2ND GEN EARLY MODEL

2^ND GEN DODGE DASH REMOVAL (EARLY MODEL WITH CABLE BLEND DOOR)

HOOD RELEASE                                                              

VACCUM CONNECTION BY THROTTLE                      

PARKING BRAKE LEVER

COLUMN WIRES (REMOVE ALL WIRES FROM COLUMN UNDER THE PLASTIC COVERS)                                      

COLUMN SHIFT INDICATOR (AUTO ONLY) 

BRAKE SWITCH PLUG                                                    

AIR BAG MODULE TO FLOOR BOLTS

METAL DASH BAR UNDER COLUMN (SO COLUMN CAN LAY DOWN FAR ENOUGH                

3 PLUGS ON BACKSIDE OF FUSE PANEL (3 CLOSEST TO THE FIREWALL)

2 DASH BOLTS BEHIND KICK PANELS (JUST NEED TO LOOSEN)                     

ANTENNA PLUG (BEHIND PASS KICK PANEL)

3 PLUGS BEHIND GLOVE BOX                                   

UNPLUG BLOWER MOTOR 

DROP COLUMN DOWN ON SEAT, DASH WILL SIT ON TOP OF COLUMN WHEN DASH REMOVED   

WINDSHIELD BOLTS (DO THESE LAST AND BE READY FOR IT TO COME OUT)

PASS SIDE OF DASH WILL REST ON PASS SEAT, DRIVER SIDE WILL SIT ONTOP OF COLUMN

CLEAN LEAVES OUT OF AIR INLET CHANEL

PARKING BRAKE INDICATOR WIRE

DO NOT NEED TO REMOVE PILLARS 

 

 

2^ND GEN HVAC HOUSING REMOVAL

HEATER HOSES                                                              HVAC LINES

VAC LINES THROUGH FIREWALL                               BOLTS BEHIND PCM

DON’T FORGET HEATER AND HVAC SEALS WHEN REINSTALLING

**optional mod, add wire mesh over inlet to HVAC housing to prevent mice from getting in